What are the various maintenance methods of the sprinkler?

the various maintenance methods of the sprinkler

maintenance methods of the sprinkler,there are several ways to replace the automatic transmission fluid of the sprinkler truck: 1. Lift the sprinkler truck, remove the fixing bolts of the lower engine guard plate, and remove the lower engine guard plate.

2. Place a suitable oil container under the automatic transmission.

3. Remove the oil drain plug and drain all the oil.

4. Install the oil drain plug with a new gasket and tighten it to the specified torque.

5. Remove the oil container and lower the vehicle.

6. Take out the automatic transmission oil dipstick, fix the transmission oil filling funnel on the automatic transmission oil dipstick tube, and fill the automatic transmission oil with the specified capacity.

7. Start the engine and run it at idle speed for 1-2min.

maintenance methods of the sprinkler has the functions of shielding from wind and rain and sun protection. If the maintenance is not good, such as scratches, The manufacturer introduces the following maintenance methods of the sprinkler:

1. When installing explosion-proof solar film, it is better to choose good quality, so as to better maintain the windshield. maintenance methods of the sprinkler

2. When cleaning the windshield glass, a special windshield glass cleaning fluid is required. Generally, the windshield glass cleaning fluid sold on the market can only be used for cleaning the outer layer of the windshield glass of the car.

To clean the front and rear windshields, you can use a commercially available glass cleaning solution, maintenance methods of the sprinkler and then dry it with a soft cloth or no towel. Wipe clean. When wiping the rear window glass, because the wireless wires and defrosting heating wires are laid on the inside of the glass, when cleaning or wiping, move left and right according to the direction of the wires, bite gently and gently, and do not rub hard in the up and down direction to prevent the wireless wires and the defrosting increase. The hot wire is displaced or even torn off.maintenance methods of the sprinkler

3. Do not use hot water to water the windshield in winter,

and do not wash the windshield with cold water in summer. maintenance methods of the sprinkler

4. On the way of driving, pay attention to large trucks that transport sand and soil.and should not be used for cleaning the inner surface of the automobile glass. It should be noted that the windshield cleaning solution containing methanol cannot be used, because it is harmful to the human body.These vehicles often drop stones and sand. If the truck is driving in front and you are too close to the vehicle, the falling stones will be enough to break your windscreen.  even crushed.

The general maintenance methods of the sprinkler repairing the inner tube of the sprinkler is as follows. maintenance methods of the sprinkler1. Inspection Check the inner tube to be repaired to determine the damaged part. For the inner tube with slow leakage, the location must be determined by water seepage, and obvious marks should be made. 2. Cleaning Remove the dirt and debris on the inner tube to ensure the quality of the repair.

3. maintenance methods of the sprinkler,Trimming Trim the damaged parts that need to be trimmed to make them meet the requirements of repair technology and quality. maintenance methods of the sprinkler
4.  Matching rubber The rubber for repairing the inner tube is reasonably selected according to the shape of the damaged hole.
5.  Grinding: Grind the joint seam and old skin to be repaired to form a rough surface.
6. .Apply glue Apply glue to the rubbed part. maintenance methods of the sprinkler
7. Completion inspection Carry out a water seepage test and inspection on the repaired inner tube to determine whether it meets the repair quality.